Error B200 is a common problem that can affect your printing process. To fix this error, you can try replacing the printhead or the tank holder. However, this might disrupt the printing process. In the event that the problem persists, you may have a problem with the waste ink tank or the paper feed mechanism.
Problem with the paper feed mechanism
If your printer is giving you the error message “Problem with the paper feed mechanism”, then the error could be caused by a blockage on the carriage. The printer may also be blocked by the wrongly installed printhead or ink cartridges. If this is the case, you can try disengaging the printer and trying again. However, you should be careful not to use too much force since it might damage the print head and carriage.
First, try unplugging the device from the power source. If the issue persists, you can try to remove the power cable from the printer. After that, try to power on the printer again. Then, open the print carriage cover and check if the error has gone away.
If all of these attempts fail, you should try resetting the printer’s printhead. For this, you should pull the printhead to remove it from the carriage. This is an important step because the print head is a fragile part. Make sure to clean it thoroughly before reseating it.
Possible causes
When you notice an error code MX922 on your Canon printer, there are a few things you can do to fix it. First, try rebooting your printer. Next, reinstall all your cartridges and make sure that the ribbon cable is properly attached to the printer head. If that does not fix the issue, try replacing the print head.
If you still have trouble printing, you might want to try resetting the printer. This can solve the problem by restoring your printer to its factory settings. To do this, hold down the On/Off button for about two seconds. After a few seconds, press the Stop button five times. Then, let the printer cool down for about an hour. Once it is completely cool, try to print a document.
Next, make sure that you have the right ink cartridges for your Canon printer. If you’re using a cartridge that is too old or has dry ink, you may experience a B200 error. If you’ve been using the printer for a long time, you may want to replace the cartridge. Using low-quality ink will have a big impact on your system and may ruin your printing experience. Try to use original Canon ink when possible.
Solution
When your Canon printer encounters the Canon B200 error message, it is important to fix the problem as soon as possible. A malfunctioning printhead or cartridge can cause this error message. Another possible cause of the error is a damaged logic board. It can be complicated to replace the main board, so it is best to contact the Canon support team for advice. Alternatively, you can take the printer to a Canon service center to fix the problem.
First, power on the Canon printer. Then, lift up the scanner unit or open the inner cover. Make sure to remove the cartridges and print heads and bend the print head so that it faces the front of the printer. If you have a 240 cord attached to the printer, then remove it.
Next, check your cartridges for ink leakage. Sometimes, this error occurs when the waste tank has run out of ink. In this case, the Canon MX922 printer will display the error b200. Restarting it can also fix this error. Reconfiguring the cartridges may also help you fix the Canon b200 error.
